Which Destination Address Is Used in an Arp Request Frame

The default is the broadcast address ffffffffffff. Since the ARP request is a broadcast it reaches all the nodes in the Subnet A which includes the e0 interface of the router but does not reach Host D.

Solved Which Destination Address Is Used In An Arp Request Chegg Com

--arpsha or -u Use.

. Thus PC1 uses an ARP to discover the MAC address of PC2. The broadcast does not. Station Address The Station Address is the MAC address of the Ethernet node.

Most operating systems will also respond if the ARP request is sent to their MAC address or to a multicast address that they are listening on. PC2 also gathers the MAC address of PC1. The IP address 127001 is the address of the local host and would receive a ping reply even if the sender is not connected to the internet.

On the transmit side it is typically transmitted as the source address of an Ethernet frame. Traceroute It is a utility that traces a packet from your computer to the host and will also show the number of steps hops required to reach there along with the time by each step. The switch sends the ARP request to all the ports excluding the port on which PC1 is connected to.

It is typically compared against the destination address in a received Ethernet frame to determine if the frame should be received or not. The ARP request packet is then encapsulated in an Ethernet frame with the MAC address of Host A as the source address and a broadcast FFFFFFFFFFFF as the destination address. --destaddr or -T Send the packets to Ethernet MAC address This sets the 48-bit destination address in the Ethernet frame header.

PC2 when receives the ARP request will then reply with an ARP response message with its MAC address.

Ccna 1 Chapter 5 V6 0 Answers

Cyberops Associate Module 8 Address Resolution Protocol

Ccna 1 Chapter 5 V6 0 Answers